Zayiko natural sharpening stone repair stone, pre-grinding / repair stone grit size: #400

Removes minor damage

With a rough grind you prepare your knife fundamentally for the grinding process in order to grind out minor damage and chipping. Depending on the condition and stress, you should pre-process your knives with a repair stone in order to subsequently perform a basic grind.

The material of the grinding stone is the high grade silicon carbide and diamondane. It is not sintered, but the method of cement casting is used.
It is sufficient to moisten the natural grinding stone before the grinding process.

Features:

Natural grinding stone: 20.00 x 7.00 x 3.00 cm
Wooden box: 21.50 x 8.70 x 5.00 cm
Grain size: #400
Wear: Very low, very fast loop effect
Suitability: for damascus steel and steel knives
Can be used with water or oil.

Instructions for use:

Open the wooden box, remove the stone and position it on a non-slip surface.
Pull the knife blade over the stone from both sides. In doing so, guide the knife evenly over the stone from the tip to the rear part of the blade.
3. always keep a flat angle of 15° to achieve an even result. Make sure that the stone is always kept moist.